You will not be able to post if you are still using Microsoft email addresses such as Hotmail etc
See here for more information viewtopic.php?f=20&t=7296
BOOKMARK THIS PAGE !
https://www.exxosforum.co.uk:8085/IP_CHECK/
You can unban yourself if needed. It also sends me reports to investigate the ban.
DO NOT USE MOBILE / CGNAT DEVICES WHERE THE IP CHANGES CONSTANTLY!
At this time, it is unfortunately not possible to whitelist users when your IP changes constantly.
You may inadvertently get banned because a previous attack may have used the IP you are now on.
So I suggest people only use fixed IP address devices until I can think of a solution for this problem!

Help to configure ClassicWB3.9 with TF330

68030 + SDRAM + IDE

Moderators: terriblefire, Terriblefire Moderator

User avatar
hardgb
Posts: 21
Joined: 25 Aug 2019 16:42

Re: Help to configure ClassicWB3.9 with TF330

Post by hardgb »

supaduper wrote: 18 Jan 2020 12:45 To stop the DF0 unreadable icon appearing on WorkBench edit your Startup-Sequence as I have done by adding this line before the first Setpach command

SetPatch NOROMUPDATE QUIET
First of all forgive me because this is my first time to open a post and thanks for the help.
I did this as you guided me more continuously in the same way.
You do not have the required permissions to view the files attached to this post.
Top
User avatar
hardgb
Posts: 21
Joined: 25 Aug 2019 16:42

Re: Help to configure ClassicWB3.9 with TF330

Post by hardgb »

Correcting: I tested it again and it worked, (I don't know why it didn't work soon).
I was impressed, as it solved both problems at once. I made a video to show.
https://www.youtube.com/watch?v=vA59n3Fb0Q4&t=13s

I just need to be able to configure Shapeshifter because it opened more and shows this error.
You do not have the required permissions to view the files attached to this post.
Top

Return to “TF330”

Who is online

Users browsing this forum: CCBot and 47 guests