Building a DIY large bed 3D printer

[Icky]

Good choice with the Duet and Duex. I hear they are worth the higher price.

Yes, I agree. Unfortunately upgrading my small printer I went with the Lerdge board which is a PITA, so much so am ditching it for a Duet. Both printers will then have the same boards. Already thinking of calling the small one Red Panda as its black with red accents. Any excuse to put a different start up banner on the screen :)

[exxos]

I'm following this.. really impressive build going there Icky! :thumbup:

[JezC]

Wondering when all the snazzy colour labels will get added onto this... :lol:

[exxos]

Wondering when all the snazzy colour labels will get added onto this... :lol:

Won't be long. I bet there's loads of labels... like "right thingy"... "left thingy" , "upper left thingy"... be like 80 of um....

[JezC]

Yes, just surprised it's not already got the first few on there (if only as a temporary aide memoire)... :hide:

[Icky]

Wondering when all the snazzy colour labels will get added onto this... :lol:

Won't be long. I bet there's loads of labels... like "right thingy"... "left thingy" , "upper left thingy"... be like 80 of um....

Yes, just surprised it's not already got the first few on there (if only as a temporary aide memoire)... :hide:

:) - just wait.

I think I have found my replacement for labels on this printer to satisfy my ocd, braided cable sleeves in white.

[Icky]

There is life in the Giant Panda. Got all the steppers wired in and tried out a bit on movement.

[exxos]

:excited: :excited: :excited: :excited:

[Icky]

Now I have the fun part of all the wiring looms this afternoon. Reels of braiding and heat shrink tubing to keep it all tidy.

[rpineau]

It's ALIVE !!!!!!!!!.....
:thumbup: :cheers: