Hey peeps!
Finally got myself on here... been drooling over the shop gubbins for ages and only discovered there was a forum today!!
I've an Atari 1040 STE that i got a while back... case is shot... :( but it runs ok I think! :D
I'm gonna use it for chiptunes (MaxYMiser) and other music so am planning a few upgrades... Already added 4MB of ram
Expect lots of pointless questions as I never seem to get the search function working properly on these sites!
I'm a gamer, chiptune fanatic, Vaper, Music Nerd etc... any questions say hi!
I suffer with depression so if i react wierdly to something... i've probably taken it the wrong way! (sorry in advance for that!)
I recently ran GemBench... is my STE doing ok???
You will not be able to post if you are still using Microsoft email addresses such as Hotmail etc
See here for more information viewtopic.php?f=20&t=7296
See here for more information viewtopic.php?f=20&t=7296
BOOKMARK THIS PAGE !
https://www.exxosforum.co.uk:8085/IP_CHECK/
You can unban yourself if needed. It also sends me reports to investigate the ban.
https://www.exxosforum.co.uk:8085/IP_CHECK/
You can unban yourself if needed. It also sends me reports to investigate the ban.
DO NOT USE MOBILE / CGNAT DEVICES WHERE THE IP CHANGES CONSTANTLY!
At this time, it is unfortunately not possible to whitelist users when your IP changes constantly.
You may inadvertently get banned because a previous attack may have used the IP you are now on.
So I suggest people only use fixed IP address devices until I can think of a solution for this problem!
At this time, it is unfortunately not possible to whitelist users when your IP changes constantly.
You may inadvertently get banned because a previous attack may have used the IP you are now on.
So I suggest people only use fixed IP address devices until I can think of a solution for this problem!
Hi! Someone else from Newcastle!!
-
Shugs81
- Posts: 33
- Joined: 14 Jul 2018 12:48
Hi! Someone else from Newcastle!!
You do not have the required permissions to view the files attached to this post.
-
exxos
- Site Admin

- Posts: 27908
- Joined: 16 Aug 2017 23:19
- Location: UK
Re: Hi! Someone else from Newcastle!!
:welcomewave:
You need to load in a STE benchmark file as your comparing a ST to STE there. See the readme file with GB6 for more info.
-
Shugs81
- Posts: 33
- Joined: 14 Jul 2018 12:48
Re: Hi! Someone else from Newcastle!!
Aaahhhh... Will try it again then!! 😁 Oops...
Who is online
Users browsing this forum: CCBot and 16 guests