A while ago I purchased a DB19 connector here to make a SCART/RGB cable for testing Atari Falcons as I repair them; I needed something to feed into my PVM. Now that I actually own my own Falcon, I'd like to complete the cable but I'm having difficulty finding a DB19 shroud/hood for any reasonable price shipped to Toronto, Canada (stuff I see online cost more than an entire SNES or Sega Genesis SCART RGB cable - for a piece of plastic!)
I wish Exxos sold the hood in the store, but I can't find it. Suggestions of where this can be purchased?
You will not be able to post if you are still using Microsoft email addresses such as Hotmail etc
See here for more information viewtopic.php?f=20&t=7296
See here for more information viewtopic.php?f=20&t=7296
BOOKMARK THIS PAGE !
https://www.exxosforum.co.uk:8085/IP_CHECK/
You can unban yourself if needed. It also sends me reports to investigate the ban.
https://www.exxosforum.co.uk:8085/IP_CHECK/
You can unban yourself if needed. It also sends me reports to investigate the ban.
DO NOT USE MOBILE / CGNAT DEVICES WHERE THE IP CHANGES CONSTANTLY!
At this time, it is unfortunately not possible to whitelist users when your IP changes constantly.
You may inadvertently get banned because a previous attack may have used the IP you are now on.
So I suggest people only use fixed IP address devices until I can think of a solution for this problem!
At this time, it is unfortunately not possible to whitelist users when your IP changes constantly.
You may inadvertently get banned because a previous attack may have used the IP you are now on.
So I suggest people only use fixed IP address devices until I can think of a solution for this problem!
[WANTED] DB19 shround / hood ..
-
DoG
- Posts: 1290
- Joined: 07 Apr 2018 12:26
Re: [WANTED] DB19 shround / hood ..
Maybe someone can print 2 of these for you in Canada?
Otherwise they can be ordered on eBay of course.
Otherwise they can be ordered on eBay of course.
-
leonk
- Posts: 39
- Joined: 14 Apr 2024 03:04
Re: [WANTED] DB19 shround / hood ..
Thank you. I didn't think about 3D printing! I'll look into that.
-
krupkaj
- Posts: 19
- Joined: 25 Dec 2017 18:09
Re: [WANTED] DB19 shround / hood ..
I have an STL for DB19 hood ready at printables here:
https://www.printables.com/cs/model/323 ... b-konektor
https://www.printables.com/cs/model/323 ... b-konektor
Who is online
Users browsing this forum: CCBot and 14 guests