Ube switch question?

[Darklord]

So I finally picked up one of those nice Dell 27" monitors that a lot of people have
been going on about. It is a nice monitor.

I've been using one of the Ube switch's, Mark IV I think, that has "Make Atari Great Again"
stamped on it.

It works great, picture is awesome. The only thing is, it always boots up in Hi-res. I can
switch it to Med-res by pressing the button but as soon as I turn the machine off, it defaults
back to Hi-res.

Is there a way to make it use Med-res all the time instead of defaulting to Hi-res? Thanks.

[exxos]

Doesn't sound like a official once I was buying from urban . can you post a image ?

IIRC you held down the button for a few seconds to store the value.

[stween]

IIRC you held down the button for a few seconds to store the value.

are you KIDDING me, I've been nudging the button to get the correct mode for years

[exxos]

IIRC you held down the button for a few seconds to store the value.

are you KIDDING me, I've been nudging the button to get the correct mode for years

viewtopic.php?f=27&t=161

[stween]

are you KIDDING me, I've been nudging the button to get the correct mode for years

viewtopic.php?f=27&t=161

"Every time I learn something new, it pushes some old stuff out of my brain"

[exxos]

"Every time I learn something new, it pushes some old stuff out of my brain"

Know the feeling. My brain has a high-rate turnover of information. Here today, Gone tomorrow.

[sporniket]

"Every time I learn something new, it pushes some old stuff out of my brain"

Know the feeling. My brain has a high-rate turnover of information. Here today, Gone tomorrow.

**insert here a joke about cache memory, shortage of components, etc...**

[Darklord]

I had thought there was a way to do it, just couldn't remember.

Thanks everyone.

PS I've seen 3D cases for the ST2VGA version of this switch, is
there one for this version? I did a search "ube switch 3d case"
but didn't see anything...