With my TF530 dcache/dburst/iburst show up as N/A in SysInfo.
Is that due to Kick 1.3 not supporting data cache or something else?
Clicking on "All" immediately gets punished by a Guru...
You will not be able to post if you are still using Microsoft email addresses such as Hotmail etc
See here for more information viewtopic.php?f=20&t=7296
See here for more information viewtopic.php?f=20&t=7296
BOOKMARK THIS PAGE !
https://www.exxosforum.co.uk:8085/IP_CHECK/
You can unban yourself if needed. It also sends me reports to investigate the ban.
https://www.exxosforum.co.uk:8085/IP_CHECK/
You can unban yourself if needed. It also sends me reports to investigate the ban.
DO NOT USE MOBILE / CGNAT DEVICES WHERE THE IP CHANGES CONSTANTLY!
At this time, it is unfortunately not possible to whitelist users when your IP changes constantly.
You may inadvertently get banned because a previous attack may have used the IP you are now on.
So I suggest people only use fixed IP address devices until I can think of a solution for this problem!
At this time, it is unfortunately not possible to whitelist users when your IP changes constantly.
You may inadvertently get banned because a previous attack may have used the IP you are now on.
So I suggest people only use fixed IP address devices until I can think of a solution for this problem!
DCache/Burst with Kick 1.3?
Moderators: terriblefire, Terriblefire Moderator
-
pipper
- Posts: 43
- Joined: 23 Apr 2019 05:55
Re: DCache/Burst with Kick 1.3?
"SetCpu" from Aminet did the trick for me. It also has a nice FASTROM option to map Kickstart into RAM.
SetCPU CACHE BURST FASTROM
Brings SysInfo on a 50Mhz TF530 on par (if not above) a Blizzard1230-IV.
The IDE speed is also phenomenal... up to 4.8mb/s via ide.device
SetCPU CACHE BURST FASTROM
Brings SysInfo on a 50Mhz TF530 on par (if not above) a Blizzard1230-IV.
The IDE speed is also phenomenal... up to 4.8mb/s via ide.device
Who is online
Users browsing this forum: CCBot and 8 guests