Kodak80 H4F build

[kodak80]

Good spot. Changed and boots to a green desktop now.

IMG_1030.jpeg (732.35 KiB) Viewed 3480 times

[kodak80]

Okay, now some tests.

External Hard disk: tested and working
Internal Hard disk (20 pin): tested and working
Internal Hard disk (24 pin): untested
Internal Floppy: not working - drive motor activates, keyboard and floppy LED light up but nothing happens after that
External Floppy: not working - same result as internal drive
YM audio output: tested and working
MIDI output: tested and working
MIDI input: untested
Mouse: tested and working
Keyboard: tested and working
Video output 13 pin DIN: High res: tested and working
Video output 13 pin DIN: Low/Medium res: tested and working
Video output VGA: untested
Serial: untested
Parallel: tested and working - tested with PARCP USB file transfers
RTC: untested
Cartridge port: untested
4x Expansion ports: untested
Blitter: untested
Boot TOS rom: tested unjumpered: boots to TOS
Boot TOS rom: tested jumpered: not working but might be my dual rom - further testing needed

Gembench test results:

IMG_1085.jpeg (590.08 KiB) Viewed 3446 times

[kodak80]

Paralell port now tested and works fine. List in previous post updated.

I have replaced the WD1772, DMA and Yamaha chips but floppy still not working. Motor activates on drive but nothing after that.

IMG_1102.png (3.24 MiB) Viewed 3406 times

[exxos]

Have you checked the 1772 clock to see if 8mhz is there?

Also your AB swap jumpers look wrong.

viewtopic.php?t=2785