Can all registered uses please login, even just for a few minutes..
It helps build a picture where our "good traffic" is coming from..
Thanks :)

3-D printer infill oddity ?

This chat forum will appear to guests and bots. IE will appear on search engines etc. If you do not want your appearing publicly then please use the original chat forum.
Post Reply
User avatar
exxos
Site Admin
Site Admin
Posts: 28712
Joined: Wed Aug 16, 2017 11:19 pm
Location: UK
Contact:
Contact exxos

3-D printer infill oddity ?

Post by exxos »

Does anyone understand why this happens ?

I am just using the fast honeycomb infill (But is irrelevant it seems which one I use) Where I have a wall thickness of 5 layers.. But when it does the honeycomb fill it also does the lines I point to ?!

Capture.JPG
Capture.JPG (51.5 KiB) Viewed 692 times

So why doesn't the infill just extend further instead of messing about with that tiny squiggle line ?!

I am using simplified 3-D, but I also see the same after installing Cura.
Top
Post Reply

Return to “CHAT FORUM PUBLIC”