You can actually have an FPU with the TF1230

[terriblefire]

I have a revision of the A1200 2B board and I do not see a jumper for 28MHz FPU on it, I also do not see such a possibility in the diagram. I soldered the FPU socket and it works fine for me, but where can I find this 28MHz jumper for FPU on the board?

He didnt say a jumper. He said a jumper wire.

You need to lift the FPU CLK pin and solder a jumper wire to the 28Mhz clock

[markus0321]

I have a revision of the A1200 2B board and I do not see a jumper for 28MHz FPU on it, I also do not see such a possibility in the diagram. I soldered the FPU socket and it works fine for me, but where can I find this 28MHz jumper for FPU on the board?

He didnt say a jumper. He said a jumper wire.

You need to lift the FPU CLK pin and solder a jumper wire to the 28Mhz clock

I'm sorry I didn't understand exactly. I checked and soldered the FPU CLK signal to the generator on the board using kynar and it works fine with 28MHz frequency on FPU and with TF1230 :-)

[Amifun]

Anyone tested more how high they can reliable clock the mbo fpu with tf1230 ? =)

[patracy]

Is there any way to trick the onboard FPU to be used/seen by the TF1260 like the TF1230 can?

[alenppc]

Is there any way to trick the onboard FPU to be used/seen by the TF1260 like the TF1230 can?

No, as the 060 lacks the external FPU interface. However, using SoftIEEE will give you a faster performance than a 68882 would.