TF536 no RAM detected

[ninjafahrer]

Hello Community,
I ve just finished the built of 2 TF536 cards.
With DIAGROM 1.2.1 I ll get them to boot, but on both cards no memory is detected.

Where can I start tracking the errors?

The Firmware I ve flashed was:
tf536r2_main_top_AMIGA_FULL_PHASE_7.jed

It is running on an AMIGA 500 REv 8A1 Board.

[Maximilian]

Could you take some pictures of the ram from both sides and post them?

[terriblefire]

Could you take some pictures of the ram from both sides and post them?

Go to memory menu and then option 6 Complete memory detection... post results.

[ninjafahrer]

card 1:
total detected memory 0kb

autoconfig
ZORRO III card detected and mapped to $40000000-$44000000

card2:
total detected memory 0kb

autoconfig
All bords done - nothing detected

[terriblefire]

autoconfig
ZORRO III card detected and mapped to $40000000-$44000000

That was autoconfig not complete memory detection.

[ninjafahrer]

What could be my next steps chasing down this topic?

[terriblefire]

What could be my next steps chasing down this topic?

Do complete memory detection. Please do whats asked. You did autoconfig! I dont think there is anything wrong.

[ninjafahrer]

both cards are showing total detected memory 0kb

[terriblefire]

both cards are showing total detected memory 0kb

ok go to memory editor... go to address 40000000 and start editing and see what gets retained and what does not

[ninjafahrer]

If I enter "FF" all gets retained,
if I enter "00" I ll get 00 00 04 00 00 00 04 00 00 00 04 00 00 00 04 00