PhilCs blog / the latest things hes broken(fixed)

[PhilC]

@rubber_jonnie yeah I've just updated it but it's still misbehaving

[rubber_jonnie]

@rubber_jonnie yeah I've just updated it but it's still misbehaving

@PhilC Oh rubbish

[PhilC]

I think it's one or two bits that have died on it. Eproms that are blank its saying they aren't and is failing to write correctly, just writing garbage.

[exxos]

have you tried a different USB cable ? cheaper ones tend to screw up on all sorts of stuff especially when USB is used for power.

[PhilC]

have you tried a different USB cable ? cheaper ones tend to screw up on all sorts of stuff especially when USB is used for power.

Yes I did as I've had that problem too.

[rubber_jonnie]

@rubber_jonnie yeah I've just updated it but it's still misbehaving

@PhilC I just realised you said you updated it, but if I recall there is a way to reflash the firmware, does rely on some disassembly and a bit of soldering though, and if I recall correctly a PickIt to do the programming.

It's how I upgraded my original TL866 to add functionality.

[PhilC]

@rubber_jonnie it was like it before and after the update and has been getting progressively worse.

I'll order another one from Amazon and see how we go I think but thanks for the suggestions.

[Tomswork]

Just a note of trouble I have a tl866 ii and have had to replace some of the capacitors in it shorted and cause all sorts of random problems


Tom

[rubber_jonnie]

@rubber_jonnie it was like it before and after the update and has been getting progressively worse.

I'll order another one from Amazon and see how we go I think but thanks for the suggestions.

@PhilC No worries, fingers crossed you'll get one soon.

[PhilC]

So I had a few extra bits and pieces laying around and decided if I could get them all playing nice together with the H4.

That was until my eprom programmer packed up, so I couldn't burn a copy of Emutos to get it all up and running.

It passes all the Ram tests etc with Diagrom though, so hopefully when the new programmer arrives today I can get it running.

20200328_122452.jpg (449.76 KiB) Viewed 3884 times