exxos build

[exxos]

Are we going to see a newly born H4 this week?

Will it be @exxos or will it be @rubber_jonnie

Doubt it be me.. not this week.

[exxos]

As I am too lazy to go and desolder any DB19's , which probably won't fit anyway..

The closest ones I can find which I have in stock ( https://www.exxosforum.co.uk/atari/store2/#0034 )

Capture.JPG (67.38 KiB) Viewed 4464 times

I pushed the connector towards the back a little to line up the holes better.. Then forced in a bolt to align it while soldering ( I am good at shoving large shafts into tight places)

2.JPG (62.98 KiB) Viewed 4464 times

Bodge fix #1 done

[exxos]

Fixes in motion...


DTACK FIX

IMG_4935.JPG (343.8 KiB) Viewed 4446 times

BG PULL UP FIX

IMG_4936.JPG (284.43 KiB) Viewed 4446 times

SIMM FIX

IMG_4937.JPG (261.37 KiB) Viewed 4446 times

RS232 bodge wire

IMG_4938.JPG (305.96 KiB) Viewed 4446 times

RS232 trace cut.

IMG_4939.JPG (338.29 KiB) Viewed 4446 times

Need to lift up the 3 DAC pins.. It does not actually looked like a fix was documented for this in the fixes section...

[exxos]

DAC FIX..

I lifted up the three pins for now that should be fine...

IMG_4941.JPG (271.87 KiB) Viewed 4440 times

[exxos]

Next up salvaging some connectors and chips from a donor board...

IMG_4943.JPG (121.73 KiB) Viewed 4431 times

IMG_4944.JPG (103.83 KiB) Viewed 4431 times

[PhilC]

Any top tips for getting that cart port into the H4 with all the bent pins? I found it a major pain in the butt.

[exxos]

Any top tips for getting that cart port into the H4 with all the bent pins? I found it a major pain in the butt.

I have the same problem with the DIP 68000's, hence moving to PLCC68

[PhilC]

Good point. I get fed up and solder female headers onto my tester DIP CPUs.

[exxos]

Ta'Daaa!

IMG_4945.JPG (402.62 KiB) Viewed 4407 times

IMG_4946.JPG (382.38 KiB) Viewed 4407 times

Passed 28 loops

[Icky]

- another H4 is born.