PhilC's H4 Mongrel edition build x 3

Post by **Icky** » 29 Nov 2019 21:10

Have you got to the I hate sockets stage yet @PhilC

Post by **PhilC** » 29 Nov 2019 21:12

Icky wrote: 29 Nov 2019 21:10 Have you got to the I hate sockets stage yet @PhilC

Oh I hated them the other day

Post by **exxos** » 29 Nov 2019 21:14

PhilC wrote: 29 Nov 2019 21:12
Icky wrote: 29 Nov 2019 21:10 Have you got to the I hate sockets stage yet @PhilC
Oh I hated them the other day

I got a whole thread on how much I hate sockets :lol:

Post by **PhilC** » 29 Nov 2019 21:37

which way round does the reset chip go?

and a 747 is the same as a 7407 right?

DoG · Post by **DoG** » 29 Nov 2019 21:47

PhilC wrote: 29 Nov 2019 21:37 which way round does the reset chip go?

The pin that is larger/wider is ground (pin 1) and this is the pad on the bottom/left on the board (closest to R13).

Post by **PhilC** » 29 Nov 2019 21:49

Thanks @DoG

Edit:

Sods law I got it the wrong way round then

20191129_213556.jpg

Post by **PhilC** » 29 Nov 2019 22:00

And I just found out that a 747 isn't the same as a 7407, doh. Time to raid the chip pile again.

Post by **exxos** » 29 Nov 2019 22:06

PhilC wrote: 29 Nov 2019 22:00 And I just found out that a 747 isn't the same as a 7407, doh. Time to raid the chip pile again.

747 is a op-amp...

Post by **PhilC** » 29 Nov 2019 22:17

Yeah I should have googled it earlier. Lesson learned.

Post by **Icky** » 29 Nov 2019 22:30

exxos wrote: 29 Nov 2019 22:06 747 is a op-amp...

Or a jumbo jet. :sorry: I just couldn’t resist.

exxos's Atari, Amiga & retro forum