exxos blog - random goings on

[exxos]

Box of 4MB STFM boards arrived I think I got 50 made... time to start testing them

IMG_4454.JPG (294.9 KiB) Viewed 4615 times

[exxos]

Finally had five seconds to look at this again... Basically there is not enough "IO power" in a GAL22V10 I'm actually one output pin short in order to put the AB SWAP in that GAL as well

so either the ABSWAP just remains as jumpers, or I move to the ATF1502... Which seems a bit of a overkill for this part of the circuit

In order to keep things simple, I will likely just stick with a normal 22V10 and port over my V7 floppy mod directly.

meh.jpg (150.12 KiB) Viewed 4556 times

[exxos]

Added in the PLCC version of the MFP. I have a stack of them anyway and theres room for it

52.jpg (85.62 KiB) Viewed 4550 times

[PhilC]

Mongrel is going to be an understatement at this rate

[exxos]

Mongrel is going to be an understatement at this rate

Yeah, its a mash up of anything which will fit at the moment

Wonder if I should integrate the diagnostic cart as well Must...Stop... Having.. Ideas...... So MSHI is now a new shortie

[PhilC]

Lol, could come up with a few more if you wanted (ide)

[exxos]

Lol, could come up with a few more if you wanted (ide)

IDE not finished yet Pretty sure Icky broke the boards... Though if by some mega huge sugar-feed turbo effort by everyone, in that we got the IDE2 working quickly, we could consider integrating it.. but I think nothing else will be ready in time for the H2 production run.

BTW Phil, do you have a Atmel programmer to program the ATF15xx series ? (can't remember)

[Icky]

Lol, could come up with a few more if you wanted (ide)

IDE not finished yet Pretty sure Icky broke the boards... Though if by some mega huge sugar-feed turbo effort by everyone, in that we got the IDE2 working quickly, we could consider integrating it.. but I think nothing else will be ready in time for the H2 production run.

BTW Phil, do you have a Atmel programmer to program the ATF15xx series ? (can't remember)

Not broken yet Just need to get the two we have working.

[PhilC]

IDE not finished yet Pretty sure Icky broke the boards... Though if by some mega huge sugar-feed turbo effort by everyone, in that we got the IDE2 working quickly, we could consider integrating it.. but I think nothing else will be ready in time for the H2 production run.

BTW Phil, do you have a Atmel programmer to program the ATF15xx series ? (can't remember)

Not broken yet Just need to get the two we have working.

Now Now, the breaking bit is my job and yes I did get an ATF programmer..... its in the pile on the floor, somewhere.

[Icky]

Not broken yet Just need to get the two we have working.

Now Now, the breaking bit is my job and yes I did get an ATF programmer..... its in the pile on the floor, somewhere.

Thats good to know as Exxos and I have been doing some more work on the Flashy Clock board today and have some updates but they will require programming the ATF1508 on the board. I will post on the Flashy Clock thread later.