:( sad newsterriblefire wrote: 29 Dec 2018 20:45 Ok.. maybe the TF534 isnt dead... but its not getting released until it formats a floppy on the Atari ST.
You will not be able to post if you are still using Microsoft email addresses such as Hotmail etc
See here for more information viewtopic.php?f=20&t=7296
See here for more information viewtopic.php?f=20&t=7296
BOOKMARK THIS PAGE !
https://www.exxosforum.co.uk:8085/IP_CHECK/
You can unban yourself if needed. It also sends me reports to investigate the ban.
https://www.exxosforum.co.uk:8085/IP_CHECK/
You can unban yourself if needed. It also sends me reports to investigate the ban.
DO NOT USE MOBILE / CGNAT DEVICES WHERE THE IP CHANGES CONSTANTLY!
At this time, it is unfortunately not possible to whitelist users when your IP changes constantly.
You may inadvertently get banned because a previous attack may have used the IP you are now on.
So I suggest people only use fixed IP address devices until I can think of a solution for this problem!
At this time, it is unfortunately not possible to whitelist users when your IP changes constantly.
You may inadvertently get banned because a previous attack may have used the IP you are now on.
So I suggest people only use fixed IP address devices until I can think of a solution for this problem!
TF534 doesn't boot under KS 3.1.4
Moderators: terriblefire, Terriblefire Moderator
-
8 Bit Dreams
- Moderator Team
- Posts: 785
- Joined: 09 Nov 2018 07:12
- Location: Germany
Re: TF534 doesn't boot under KS 3.1.4
Retro computer hardware & repair in Germany
-
terriblefire
- Admin sponsor
- Posts: 5675
- Joined: 28 Aug 2017 22:56
- Location: Glasgow, UK
Re: TF534 doesn't boot under KS 3.1.4
I just dont want to release a board which gets replaced in 4 weeks.
———
"It is not necessarily a supply voltage at no load, but the amount of current it can provide when touched that
indicates how much hurting you shall receive."
"It is not necessarily a supply voltage at no load, but the amount of current it can provide when touched that
indicates how much hurting you shall receive."
-
terriblefire
- Admin sponsor
- Posts: 5675
- Joined: 28 Aug 2017 22:56
- Location: Glasgow, UK
Re: TF534 doesn't boot under KS 3.1.4
I can confirm the TF534 does work with 3.1.4
———
"It is not necessarily a supply voltage at no load, but the amount of current it can provide when touched that
indicates how much hurting you shall receive."
"It is not necessarily a supply voltage at no load, but the amount of current it can provide when touched that
indicates how much hurting you shall receive."
Who is online
Users browsing this forum: CCBot and 9 guests