STF Remake Case ideas etc

[PhilC]

Evening All,

So todays little job is to make a backplane for the STF, so that I can 3d print it once it's complete.

The case is going to be half 3d printed and half acrylic sheet.

Here's the progress so far.

Screenshot 2018-12-10 at 22.00.44.png (247.76 KiB) Viewed 6605 times

Yesterday I'd been working on the keyboard for the STF, the idea is to have a wired keyboard a bit about the Mega ST one. Quick photo below, again will 3d print this and use acrylic sheet, just getting the ideas together first.

Screenshot 2018-12-10 at 22.05.19.png (342.16 KiB) Viewed 6605 times

[exxos]

[viking272]

Hi PhilC,

Did you get this printed OK?
I'm interested in the measurements for the ST series for the backplane.

Just wondering if they're all the same (bar the modulator addition)?
Did you have the old one to make your design from?