ST-IDE-ROM Dev Board v1 - BETA Testers

[rubber_jonnie]

Problem is I don't know if the chips were protected or not.. Quite possibly they are protected... But I guess you could see if your programmer would even recognise the device..

Though at the time I was doing this stuff you had to had the official ATMEL programmer... Maybe things have changed now.. @agranlund @PhilC ?

I don't think I did, need to go have a look what I've got, but as I said, I think they came pre-programmed for me as evidenced by the flag sticker on the CPLD, not something I'd do..

[exxos]

Had a route around and found the latest boards ! Question is, can I be really bothered to build one of these up

IMG_4494.JPG (396.56 KiB) Viewed 1842 times

Looking at the schematic, I am already puzzled, because for some reason I removed the series resistor off the LED

[rubber_jonnie]

Looking at the schematic, I am already puzzled, because for some reason I removed the series resistor off the LED

[exxos]

ahhh

viewtopic.php?p=34718&hilit=led#p34718

I thought the only possible way will be either multiplexing or a fixed resistor built into the LED which I don't normally use..

So yay me for writing this stuff down somewhere!

Only possible problem is this likely assumes a CF card being standard in how it operates.. So I guess if the LED catches fire.. put a 1K in series with it..

[PhilC]

@exxos there are other methods now to program them now, even copy atmel programmers apparently, I've got a proper one that I got through eBay..

[exxos]

Sooooooo close... can't find anymore bits

IMG_4495.JPG (317.05 KiB) Viewed 1815 times

It's also a reminder how completely annoying through-hole soldering is !