POV C5B build - Cyber Legends board

[exxos]

They offered me a $30 PCBWay credit towards a future purchase...

Told them "no thanks".

Thats pretty bad customer service :(

JLC have done good prints so far for me. But not used FDM printing.

JLC printed these in metal, very impressive !

viewtopic.php?p=107075#p107075

[coonsgm]

I should have ordered the print in resin. I just didn't think FDM would end up as badly as it did.

[coonsgm]

I'm cautiously optimistic.

After telling PCBWay "no" twice for $33 and $40 of store credit and that I'm only interested in a replacement print, resin if that is what they recommend for better print quality they just asked me to place an order that they will cover.

We'll see....I am cautiously optimistic.