Sold, possible sale of 2 xShort ST STM 520 4MB with ST536 built in

[exxos]

Does the solder joints on the bottom of the IDE socket hit that MB socket..

[PhilC]

Does the solder joints on the bottom of the IDE socket hit that MB socket..

No they don't but are next to them. They would be on the top for a regular installation

[exxos]

No they don't but are next to them. They would be on the top for a regular installation

I will shift it 18mm if that seems best.. will take me a few weeks to get to it though.

BTW this should be read if you not seen it so far... viewtopic.php?p=124870#p124870

[PhilC]

No they don't but are next to them. They would be on the top for a regular installation

I will shift it 18mm if that seems best.. will take me a few weeks to get to it though.

BTW this should be read if you not seen it so far... viewtopic.php?p=124870#p124870

Yes I had seen that. Do you want me to test the clock patch board on an ST536?

[exxos]

Yes I had seen that. Do you want me to test the clock patch board on an ST536?

Yeah might be an idea just in case..

[PhilC]

Yes I had seen that. Do you want me to test the clock patch board on an ST536?

Yeah might be an idea just in case..

Ok, I've got one unallocated and unbuilt ST536 left and enough parts to build it. I'll use it with that then.

[exxos]

@PhilC I aint moving it again!

I need to sort out the clock part next..

Capture.PNG (60.02 KiB) Viewed 1100 times

[PhilC]

@exxos such a lot of work for a small move.

[PhilC]

1 sold, I can build up a second if there is any interest.

[PhilC]

Now sold.