kodak80 H5 A3 builds

[kodak80]

I have a question regarding SMD resistor network (RN) components. Does the orientation of SMD RN on the H5 boards matter?

Nope, they are just single resistors in a "pack of 4".

Okay, good to know. Thank you.

[kodak80]

I have put aside the A3 board for now and started to build my three B1 boards up.

Okay, 3 years later and I have finally got back to looking at why this H5 A3 board was not booting. Turns out the fix on the reset IC22 was soldered to the GND pin 1 and not pin 2



The board is now booting and shows a desktop so another one comes to life.

Here is the correct location of the IC22 bodge wire:

reset H5 A3 fixed.jpg (252.59 KiB) Viewed 8708 times

I guess this means that my other three A3 boards should now be built up.

[kodak80]

Having gotten the first H5 A3 board booting, I now have board 2 alive and booting.

On board 2, I added all the fixes bodge wires on the top leaving the bottom side clear of wires.

Board 3 and 4 will also be brought to life.

[HigashiJun]

[exxos]