exxos PSU 110V wiring

[exxos]

NOTE: If anyone can has images of the original grey switching wiring with the exxos PSU wired at 110V, then please PM me..


NEW SWITCH MOUNTING (SPST)

The 110V transformer wiring is slightly different than the 230V one, but very similar. While the 230V transformer wires have BLUE and BROWN wires, the 110V has the same wires but paired with GREY and PURPLE.

newsw1.jpg (36.1 KiB) Viewed 3011 times

NOTE: I strongly suggest fitting a new PSU switch when the PSU is fitted.


SWITCH
https://www.exxosforum.co.uk/atari/store2/#0032

PSU
https://www.exxosforum.co.uk/atari/store2/#0030

[exxos]

110V PRIMARY CONFIGURATION

Grey & Brown wired together.
Purple & Blue wired together.

IMG_5448.JPG (257.52 KiB) Viewed 4631 times

Tech_Draw_2.jpg (78.03 KiB) Viewed 3013 times

Please note: Fitting is for guidance only. If not re-fitting the switch insulation boot, you must isolate mains connections with suitable heat shrink tubing . If not using a fused mains lead (no greater than 3amp fuse in the plug) , you should fit a 1 - 3 amp mains antisurge fuse in the live / hot wire between the mains connector and switch and insulate accordingly. Wires should be soldered at right angles on the switch.

[exxos]

GREY SWITCH DPST WIRING 110V

IMG_8805.JPEG (214.92 KiB) Viewed 2543 times

Thanks to @RetroPassionUK for the image.

[rubber_jonnie]

@exxos As requested, please double check and let me know if there are any errors.

110V_DPST.jpg (107.73 KiB) Viewed 2474 times

[exxos]

@exxos As requested, please double check and let me know if there are any errors.

Looks correct!

[rubber_jonnie]

@exxos As requested, please double check and let me know if there are any errors.

Looks correct!

Splendid