Should exxos design a new CT60 PSU?

[exxos]

PCB only is quickest to market. As MW modules are hard and expensive to source in the uk, people buy their own.

Or Meanwell modules pre-fitted.

Or rehash the current PSU design. Not using a transformer but 12v module front end. 5v and 3.3v get their own exxos regulation circuits where voltages can be adjusted. This would likely be the most expensive and time consuming method.

Obviously there needs to be enough demand to make them worthwhile the time and costs.

[mikro]

I don't really care about how / what is it made from, as an end user I'd appreciate:

- easy fitting (no drilling holes, ideally using the existing ones the switch etc)

- no collision with ct60, ct63, ct60e + peripherals (ctpci, ethernat, supervidel -- taking some space on the right side)

- working for both 030 and 060

[Steve]

Yeah and in my experience I think most people would like something fully built and ready to go, if people have to source power modules or do their own soldering I think it'd reduce your sales quite significantly.

[alexh]

I would want something fully assembled and tested.

What I liked about the CT60PSU was it's fitting. It fitted perfectly.

All the cables were the correct length.

The 3D printed plastics meant it looked stock. Plus the speaker carrier was very cool if like me you wanted it to keep it as close to stock as possible.

I'd really like (and there's no reason why not) any replacement to be similar. (Easy to install, good fit, stock look externally)

The PicoPSU that I had previously was a fudge and I never liked it. I really didn't like the external AC/DC laptop PSU.

[exxos]

I'm all for easy install. But things like connectors on mains I draw the line at. Having worked on various electronics and electromechanical equipment, failures were, for the most part, always connectors.

So there's the problem.. People want plug and play and go with such solutions over mine because my stuff needs soldering. People see quick and simple as better, when in my experience, it's not.

Take for example enclosed fuse holders. I've seen so many melt into a blob.. Constant use, a bit of heat builds up, contacts tend to ark even a tiny bit. Starts to heat up the fuse and holder.. 6 months later it's not even recognisable as a fuse holder anymore..

[alexh]

So there's the problem.. People want plug and play and go with such solutions over mine because my stuff needs soldering. People see quick and simple as better, when in my experience, it's not.

That is not the case here. You didn't sell anything in this space. If you had, then I would have considered / favoured it given my previous positive experience with Exxos products.

If vendors ignore their customers requirements then they go elsewhere.

If customers ignore vendors recommendations they get an inferior experience.

There is no need for soldering on this item (though I appreciate it was in reference to other products)