Can all registered uses please login, even just for a few minutes..
It helps build a picture where our "good traffic" is coming from..
Thanks :)

PSU bracket remake ?

All information relating to the Alpha plus all the WIP threads etc.
Post Reply
User avatar
PhilC
Moderator
Moderator
Posts: 7524
Joined: Fri Mar 23, 2018 8:22 pm

Re: PSU bracket remake ?

Post by PhilC »

It does look promising. I think I'll steal the honeycomb fill idea for future projects as itll save on material. Not sure about the print time though.
If it ain't broke, test it to Destruction.
Top
User avatar
exxos
Site Admin
Site Admin
Posts: 28670
Joined: Wed Aug 16, 2017 11:19 pm
Location: UK
Contact:
Contact exxos

Re: PSU bracket remake ?

Post by exxos »

PhilC wrote: Wed Apr 24, 2019 8:02 am It does look promising. I think I'll steal the honeycomb fill idea for future projects as itll save on material. Not sure about the print time though.
"infill" will help a lot on this, but I wanted the holes to aid in air flow around the PSU a bit more.

I had to make the base 3mm larger on the top and bottom to get the strength.. I may down this to 4mm if its strong enough.. There is currently only 2mm between the bottom of the PSU and the base (4mm original) so not much for pins and solder blobs on the bottom of the original PSU.. Though this is more intended for my PSU's anyway.

EDIT:

More progress in my blog about this project... https://www.exxosforum.co.uk/forum/viewt ... 140#p22100
Top
Post Reply

Return to “ALPHA DEVELOPMENT INFO”