exxos blog - random goings on

[exxos]

Started printing my new spool holder...

Capture.JPG (121.02 KiB) Viewed 4958 times

Thinking this is looking like it could double up for something else as well...

IMG_5209.JPG (72.56 KiB) Viewed 4958 times

[exxos]

A bit better image... I don't know why, but all these STL files I download always seem to have some "dump fault" in them When I do my own files and print them they'll print out fine...

IMG_5210.JPG (73.24 KiB) Viewed 4949 times

[rubber_jonnie]

@exxos I do hope that pink matches the recently repaired TV?

What is it a spool for out of curiosity?

[exxos]

@exxos I do hope that pink matches the recently repaired TV?

I think it is pretty close, may be a fraction darker

What is it a spool for out of curiosity?

It's a spool for printing stuff out with ?

[derkom]

What is it a spool for out of curiosity?

It's a spool for printing stuff out with ?

He fallen into the trap of needing a 3D printer in order to print out 3D printer parts.

[exxos]

He fallen into the trap of needing a 3D printer in order to print out 3D printer parts.

[exxos]

First part done! A bit of oozing I think on the top of it, likely because the fans were not running as they are too noisy Need to measure the fans and find some quieter ones I think..

IMG_5211.JPG (60.08 KiB) Viewed 4927 times

[exxos]

So this turned out to be a pain It did not actually fit as my printer has some locating holes, so I had to drill them out I also had to take the bottom of the printer to get at the nuts the other side

Even more annoying, I tried to link the rear fans in series to run them at half voltage, I don't know why but the whole printer went off, crashed, came back on again, and now both vans are stuck full on all the time I have just left them disconnected for now..

Also if anyone knows what this presumably MOSFET is, let me know as I cannot seem to find out what it actually is

IMG_5212.JPG (179.48 KiB) Viewed 4906 times

IMG_5213.JPG (229.2 KiB) Viewed 4906 times

IMG_5214.JPG (199.37 KiB) Viewed 4906 times

IMG_5215.JPG (262.08 KiB) Viewed 4906 times

IMG_5216.JPG (215.39 KiB) Viewed 4906 times

[exxos]

Finally done. Messed up on the top bit though, but not surprised with no supports

IMG_5217.JPG (274.67 KiB) Viewed 4890 times

IMG_5218.JPG (213.42 KiB) Viewed 4890 times

IMG_5219.JPG (231.11 KiB) Viewed 4890 times

[rubber_jonnie]

He fallen into the trap of needing a 3D printer in order to print out 3D printer parts.

indeed!!


Out of curiosity, what was wrong with the old one? Not pink enough?