ST-IDE-ROM Dev Board v1 - BETA Testers

[PaulJ]

Just feed Harry.. looked a little lean. :girldance:

[PhilC]

Just feed Harry.. looked a little lean. :girldance:

I just helped to fatten him up a bit as well :lol:

[rubber_jonnie]

He should be quite happy now, I've also fed him :)

[PaulJ]

I knew down deep Harry is a glutton.. :sigh:

[rubber_jonnie]

Oooh I forgot this: :girldance: :girldance: :girldance:

[PaulJ]

@exxos , what is the IDE connector pin pitch on the new 1.1 IDE board? Thanks

[DoG]

@exxos , what is the IDE connector pin pitch on the new 1.1 IDE board? Thanks

Check the part list/BOM in this thread. But I can help you right away, it is 2mm :D ;)

[PaulJ]

@exxos , what is the IDE connector pin pitch on the new 1.1 IDE board? Thanks

Check the part list/BOM in this thread. But I can help you right away, it is 2mm :D ;)

Oh, its the 0.0787 pitch instead of the 0.1 pitch used on the initial board. :) :)

Untitled.png

[rubber_jonnie]

It's 44 pin ide isn't it, rather than standard 40 pin.

[PaulJ]

It's 44 pin ide isn't it, rather than standard 40 pin.

Yup, the initial board used a header with 0.1" pitch. So the 0.0787402" pitch are the smaller connectors used with the 44 pin. Guess I'll have to order some one these header pins.