Flashy Clock - Yet another DEV board

[Icky]

More goodies back from the PCB manufacturer, Flashy v7. Unfortunately they could not do the boards in black

Looks like I have a busy weekend ahead with these and the Phoenix Shifter

IMG_0055.jpeg (59.92 KiB) Viewed 7408 times

IMG_0056.jpeg (60.19 KiB) Viewed 7408 times

[exxos]

Well done @Icky For squashing all that tech Into such a small space!

[Icky]

Well one Flashy v7 got built this morning. Voltera worked a charm and saved me a lot of time.

IMG_0075.jpeg (64.59 KiB) Viewed 7296 times

IMG_0074.jpeg (71.22 KiB) Viewed 7296 times

[Icky]

Sitting nicely in the H5

IMG_0077.jpeg (88.54 KiB) Viewed 7288 times

[exxos]

Got mine built up and firmware tweaks done.. Still ended up with a bodge wire but at least this version is not suffering from the DMA bus shorts now.

While finishing the firmware, I have run into a serious space limit in the PLD I cannot complete all the features I wanted to add. So we are trying to fit a second (smaller) PLD on the board to take care is of some of the logic processing. As always, one step forward, two steps back

IMG_6488.JPG (261.84 KiB) Viewed 7050 times

[Darklord]

Catching up on stuff, so sorry if I'm behind the curve...

I've got a question about the Flashy Clock.

How close are the STorm ST (and clock) and the Flashy Clock, when compared.

They seem to have very comparable specs...

Thanks.

[exxos]

@Darklord They're not actually comparable because Flashy clock is a 3.3V design primarily to use on the H5 series motherboards. We may be doing adapters for original machines in the future, but it really depends on interest.

[Darklord]

@Darklord They're not actually comparable because Flashy clock is a 3.3V design primarily to use on the H5 series motherboards. We may be doing adapters for original machines in the future, but it really depends on interest.

Oh, okay. I didn't realize they weren't for all ST's (yet).

Thanks!

[exxos]

I have been trying to print with a nozzle which is basically too big,as I do not currently have the correct size ones:(

IMG_6534.JPG (317.08 KiB) Viewed 6313 times

Use my new toy, though I am not sure the bed heater is working as the temperature is all over the place along with the soldering iron, which is not actually plugged in anyway..

IMG_6537.JPG (274.56 KiB) Viewed 6313 times

Seems there was too much paste on the pads, which I am not really surprised about.. So will try and tidy them up.. Though likely it will have to wait until I can obtain some smaller nozzles.

Capture.PNG (652.56 KiB) Viewed 6313 times

[exxos]

Managed to find a unbroken original nozzle which is a fraction smaller

Capture.PNG (1.5 MiB) Viewed 6351 times