And finally!!
Formatted the card under windows that was giving 3 bombs , re partitioned it and all is well so far.
Another lot of HD test to run tomorrow on this card and then I think I'm done until my last IDE to CF adaptor arrives from China.
I'm.sure I have a 3.5" IDE to card reader somewhere and an old IDE CDROM clicking about but that will have to wait till I can make it to the lockup
Can all registered uses please login, even just for a few minutes..
It helps build a picture where our "good traffic" is coming from..
Thanks :)
It helps build a picture where our "good traffic" is coming from..
Thanks :)
ST-IDE-ROM Dev Board v1 - BETA Testers
Re: ST-IDE-ROM Dev Board v1 - BETA Testers
If it ain't broke, test it to Destruction.
Re: ST-IDE-ROM Dev Board v1 - BETA Testers
rubber_jonnie wrote: Wed May 01, 2019 9:20 pm I left the IDE tester running all day on the Fujitsu 6.4GB laptopo drive (I set it off before going to work, not suggesting it took all day), and all was fine:
Re: ST-IDE-ROM Dev Board v1 - BETA Testers
So its all sorted now then, all cards currently working ?PhilC wrote: Wed May 01, 2019 9:53 pm And finally!!
Formatted the card under windows that was giving 3 bombs , re partitioned it and all is well so far.
Another lot of HD test to run tomorrow on this card and then I think I'm done until my last IDE to CF adaptor arrives from China.
I'm.sure I have a 3.5" IDE to card reader somewhere and an old IDE CDROM clicking about but that will have to wait till I can make it to the lockup
Re: ST-IDE-ROM Dev Board v1 - BETA Testers
Yes, all up and running. 
If it ain't broke, test it to Destruction.
Re: ST-IDE-ROM Dev Board v1 - BETA Testers
Sweet so we got no current known issues then
Re: ST-IDE-ROM Dev Board v1 - BETA Testers
Never speak to soon , you never know what I'll break next.
If it ain't broke, test it to Destruction.
Re: ST-IDE-ROM Dev Board v1 - BETA Testers
Has anyone tried connecting two drives at once?
If it ain't broke, test it to Destruction.
Re: ST-IDE-ROM Dev Board v1 - BETA Testers
Won't work on the initial board... at least I don't think so as there is no secondary decoding in the PLD... But it does decode the whole IDE range, thats why it shows up 2 IDE devices..
Re: ST-IDE-ROM Dev Board v1 - BETA Testers
That won't work as the DEV board is only setup as a master IDE interface. We have been working on the master and slave IDE circuit for the next version but are waiting on the bugs you guys find before we embark down that road. The diode patch for PhilC's Chinese CF cards has been put into the schematic already.