LarryL's H5C1 build

[LarryL]

As usual, a picture of a benchmark

BFC98972-14D0-498B-A4EB-2FE3180F406A.jpeg (315.61 KiB) Viewed 2875 times

Picture is quite nice and filling the screen perfectly (it is a NEC 1990FXd connected via your ST2VGA adapter)

This is with 16MHz and STORM active, but since Gembench is running from the Diag Card, it is running from ST RAM

The NEC is also working with 15KHz in low and mid res.
Low res much better than mid…
Repeated the benchmark in mid res

32EC671E-E41F-476E-ABB6-86839049A4B8.jpeg (283.9 KiB) Viewed 2875 times

Seems, the GEM and VDI performance is different, depending on the resolution…

Need to set-up a IDE adapter next…

[LarryL]

Ok, I call this build „done“ - for the time being…

Added a TOS/IDE Card I had laying around.
It is called TDEaL and contains two TOS2.06 EPROMS (soldered), which I deactivated, so only the IDE port is active.

6DBD067B-8CA8-4070-804D-A73CF572F8A2.jpeg (352.16 KiB) Viewed 2855 times

Had to mod the Gotek stand a bit to make it work, since the TOS/IDE card was physically blocking nearly everything because of its layout.
Had to use IO Port #4 on top of the STORM for the IDE card and connected the CF reader by ribbon cable and a male/male adapter

5B350B7F-23FC-4B4F-9A96-4A5A136E3994.jpeg (328.76 KiB) Viewed 2855 times

B97E236E-A1CC-4773-A4B0-597F6DBED009.jpeg (263.2 KiB) Viewed 2855 times

Finally installed NVDI and made the obligatory benchmark

2CAD6C63-D185-47E3-97F5-7C253B5C40EE.jpeg (335.66 KiB) Viewed 2855 times