EXXOS IDE V1.1 R1C BUILD & INSTALL INFORMATION

[rubber_jonnie]

IDE V1.1 R1C - LED 5V?

Do you also need to use PLD connections in this board?

Yes.

[dragmar]

PCB solder. I put pictures, and I have a request, if I installed something wrong, I ask for information.

IMG_20200610_224540.jpg (254.9 KiB) Viewed 7045 times

IMG_20200610_223205.jpg (232.23 KiB) Viewed 7045 times

[philbo34]

hi
is the parts list still current if fitting to an stfm.
cheers

[exxos]

hi
is the parts list still current if fitting to an stfm.
cheers

No difference from a STFM to H4.

[Icky]

PCB solder. I put pictures, and I have a request, if I installed something wrong, I ask for information.

@dragmar - I can't see anything out of place from the photos at first glance.

Do you have the ACSI_10 header pin soldered in. I could not see it from the photo. Its the one to the top left of the large PLD.

[philbo34]

forgive the prob stupid questions
are the resistors 1/4 watt
what type are the majority of the caps .
cheers

[derkom]

forgive the prob stupid questions
are the resistors 1/4 watt
what type are the majority of the caps .
cheers

0.25 W is fine for the resistors. Everything except C8 are just little ceramic caps (at least on my build), and C8 is an electrolytic.

[philbo34]

cheers for info

[thecaver99]

ivw ordered one of the bare boards just out of curiosity where would i get the image for the 27c4096 eprom or is it a matter of loading 1 image in low and other in hi space and is there anything i need to do to the roms?
looking forward to building and installing it into my stfm once i get it fixed

[exxos]

TOS images are here. https://www.exxosforum.co.uk/forum/viewt ... f=25&t=116 program 2 normally TOS104 TOS206 into it.