TF536 Bulk Order (Batch 1 Shipped)

[matt020]

But the issue remains? If Paul got a loose cap, and none of his boards are missing a cap....

I'm not a smart man, but it would say to me that someone else's' board might be missing a cap.

[PaulJ_2.0]

Happy hunting guys!!

[terriblefire]

But the issue remains? If Paul got a loose cap, and none of his boards are missing a cap....

I'm not a smart man, but it would say to me that someone else's' board might be missing a cap.

Or a cap got stuck in the packaging from the factory. A single cap missing is not gonna cause a board to fail.

In any case what can i do about it? Its highly likely that the cap would have fallen off anyway if the soldering was that bad.

EDIT: Or a cap got picked up from my desk which is full of them.

[Danoo]

Everyone else will get 1 bare board. + the remaining count in pre-assembled. works out perfectly.

Sorry forget to send the postage in the first Paypal trans. sent a second payment with the postage. That is what you get when you are watching comedy shows on TV and reading forums.

[terriblefire]

Everyone else will get 1 bare board. + the remaining count in pre-assembled. works out perfectly.

Sorry forget to send the postage in the first Paypal trans. sent a second payment with the postage. That is what you get when you are watching comedy shows on TV and reading forums.

No probs. Got it now.

I have messaged out 80% of remaining orders. This is all the 1s or 2s that have to go out, They'll get posted in order of payment. The rest of the messages will go out later tonight.

[agranlund]

EDIT: Or a cap got picked up from my desk which is full of them.

Wohooo!! Free caps! You get a cap, and you get a cap, everyone gets a caaaaap!

Sorry, I'll go away now...

[PhilC]

Does anyone know the cap rating? I want to use my free caps appropriately.

There will be free caps for everyone right?

[terriblefire]

Does anyone know the cap rating? I want to use my free caps appropriately.

There will be free caps for everyone right?

X7R higher than 6v is what i use. Really just depends what is available when i make an order.

Almost all the 0603s are 0.1uF

[terriblefire]

@redhawk668 You've not given me an address to ship to

@EzdineG No shipping in the payment.

I'm guessing there will be a few of these.

[terriblefire]

Oh I forgot to ask the other day.
I have quite a few (dozens) MT48LC16M16A2 -75 that I've had for ages, is the -75 going to cause problems?
I put them onto my rev2 prototype and they seem to be performing ok, but I've not pushed it.

I dont think there will be an issue because the ram runs at 50Mhz. But i would suspect that if you have issues.