Icky wrote: Mon May 13, 2019 5:48 pm
Nice - How sturdy is it?
There is a tiny bit of bend on it all, but really not surprised. I have increased the angle part at the back slightly.. I will probably try a better infill on the next print, as it is only 15%... If there was printed solid I still think it would bend slightly.. Is nowhere near enough to break, but it is after all plastic and not metal.. I have been trying to break it and it's not possible.
Removing the hexagon pattern in the centre did not make it any less bendy.
Icky wrote: Mon May 13, 2019 5:48 pm
So all you have left to do are some risers to fit between the PSU and motherboard?
Yeah, they will be like the floppy plastic posts, that type of thing.
I must have not taken off the thickness of the base when I measured these out 
