exxos blog - random goings on

[exxos]

Removed the nut lugs.. Also made the thickness of the whole thing 5 mm less... There is no use really overhanging the syringe barrel, it only needs to support sides and the back really. I had it before because the base of the syringe be under a lot of pressure so I did not want to risk breaking.. But thinking about it, the bulk of the pressure should be on the top side of syringe anyway.. The bottom of the syringe should be more just or alignment as opposed to strength.

Capture.PNG (90.08 KiB) Viewed 5227 times

I am a bit stuck now, as I cannot do the mounting holes until my CNC framework arrives along with the motors etc

[exxos]

Not collapsed yet

IMG_6307.JPG (210.89 KiB) Viewed 5210 times

[exxos]

Printed not sure why its got that odd couple of banding marks towards the top half ?

IMG_6308.JPG (256.08 KiB) Viewed 5202 times

EDIT:

ahhh, It looks like the print got incredibly thin towards the top as it is almost transparent looking at it now...

IMG_6309.JPG (175.58 KiB) Viewed 5199 times

[exxos]

Finally started to program and test the TOS206 decoder boards... Hopefully these will be in stock again very soon...

IMG_6310.JPG (332.82 KiB) Viewed 5187 times

[exxos]

Best Eagle routing ever!

Capture.PNG (50.75 KiB) Viewed 5140 times

[exxos]

Why is the last track never has anywhere easy to route

Capture.PNG (65.13 KiB) Viewed 4413 times

[Icky]

Why is the last track never has anywhere easy to route

Because you started from the wrong end - couldn't resist.

[exxos]

Because you started from the wrong end - couldn't resist.

Annoying thing is it was all really nice and neat routed then I realised the chips orientated how I had them, would not fit in the ST So had to swap things around which made the routing a lot harder work

[exxos]

Part 1 done...

1772.PNG (50.76 KiB) Viewed 4395 times

[Icky]

Part 1 done...

If you use those smaller BQ buffer packages we were discussing the other day you could stager the DIPs and make it slimmer similar to the H4 buffer board.

https://www.exxosforum.co.uk/forum/viewt ... 587#p20746