Project: HDMI/DVI out for STFM

[Smonson]

For those who couldn't see the photo before, sorry about the delay. Here it is again.

20171107_210215.jpg (351.25 KiB) Viewed 4938 times

[exxos]

Just need to find a HDMI cable now

IMG_3240.JPG (111.44 KiB) Viewed 5007 times

[troed]

... and connect VSYNC

[exxos]

Found a HDMI cable, only like a foot long Connected Vsync... and nothing

Oddly my TV switches to EXT input (scart) even though I select HDMI from the menu

IMG_3242.JPG (452.41 KiB) Viewed 5000 times

[troed]

There's a LED on the underside of the blue board, facing the DVI connector. You can see the LED's reflection in the connector. If it's steady red, it means the FPGA is picking up the expected 160256 cycles for each VSYNC. If it's flashing it means it isn't (which might mean the computer is doing something it shouldn't).

[troed]

Oh, and check orientation of the flat cable. edit: looks fine. Caught me out once though.

[exxos]

There's a LED on the underside of the blue board, facing the DVI connector. You can see the LED's reflection in the connector. If it's steady red, it means the FPGA is picking up the expected 160256 cycles for each VSYNC. If it's flashing it means it isn't (which might mean the computer is doing something it shouldn't).

Its just staying red... my monitor screen flickers when I power on the ST, but does nothing else.. I will see if my multisync monitor has hdmi input...

[troed]

Its just staying red... my monitor screen flickers when I power on the ST, but does nothing else.. I will see if my multisync monitor has hdmi input...

Check HALT on your CPU as well if you get no picture on another screen as well. Steady red means the GLUE is doing it's job at least.

[exxos]

Check HALT on your CPU as well if you get no picture on another screen as well. Steady red means the GLUE is doing it's job at least.

ST is running.. its loading stuff from the floppy...

[exxos]

My multisync monitor just shows this...

1.jpg (17.93 KiB) Viewed 4888 times