Can all registered uses please login, even just for a few minutes..
It helps build a picture where our "good traffic" is coming from..
Thanks :)
It helps build a picture where our "good traffic" is coming from..
Thanks :)
TF360 with Kipper2k riser
Moderators: terriblefire, Terriblefire Moderator
-
terriblefire
- Admin sponsor
- Posts: 5687
- Joined: Mon Aug 28, 2017 10:56 pm
- Location: Glasgow, UK
Re: TF360 with Kipper2k riser
@Amigaz If there is nothing further on this topic i'm inclined to delete it as it incorrectly gives the impression that the regulator should not be on botton of the TF360.
———
"It is not necessarily a supply voltage at no load, but the amount of current it can provide when touched that
indicates how much hurting you shall receive."
"It is not necessarily a supply voltage at no load, but the amount of current it can provide when touched that
indicates how much hurting you shall receive."
Re: TF360 with Kipper2k riser
Yes, you are correct.terriblefire wrote: Fri Mar 15, 2024 12:42 pm The card doesn't need to be perfectly level. i've mine hanging at about 30 degrees and it's fine. i think you have a different issue
After some further testing we can cast aside my theory that it helps to move the TF360 slightly for it to boot.
A cold boot by toggling the power switch doesn't result in a boot but pressing the reset button when it doesn't cold boot it boots every time.
I am using a brand new PSU från Amigastore.eu and have also tested my old 4A PSU
Re: TF360 with Kipper2k riser
terriblefire wrote: Sat Mar 16, 2024 6:47 pm @Amigaz If there is nothing further on this topic i'm inclined to delete it as it incorrectly gives the impression that the regulator should not be on botton of the TF360.
