Can all registered uses please login, even just for a few minutes..
It helps build a picture where our "good traffic" is coming from..
Thanks :)
It helps build a picture where our "good traffic" is coming from..
Thanks :)
EXXOS - Populated PCB Availability?
Moderators: terriblefire, Terriblefire Moderator
-
terriblefire
- Admin sponsor
- Posts: 5687
- Joined: Mon Aug 28, 2017 10:56 pm
- Location: Glasgow, UK
Re: EXXOS - Populated PCB Availability?
@go0se is your man
———
"It is not necessarily a supply voltage at no load, but the amount of current it can provide when touched that
indicates how much hurting you shall receive."
"It is not necessarily a supply voltage at no load, but the amount of current it can provide when touched that
indicates how much hurting you shall receive."
Re: EXXOS - Populated PCB Availability?
Thanks a lot! I'll pm him.
Re: EXXOS - Populated PCB Availability?
I also have them: https://www.amibay.com/showthread.php?1 ... r-the-A500Nrg wrote: Tue Jul 06, 2021 5:24 pm Any tips where/who to ask for pre-built and tested TF536 boards for A500 ? Thanks!
Re: EXXOS - Populated PCB Availability?
Is there a place where I can buy empty (or partially populated) PCB for TF536?
Re: EXXOS - Populated PCB Availability?
I have more on order for the store. Someone brought the last ones up a couple days ago.doda1200 wrote: Tue Aug 10, 2021 1:05 pm Is there a place where I can buy empty (or partially populated) PCB for TF536?
Re: EXXOS - Populated PCB Availability?
These will be back in stock later today, shipping will however not start until next week.
Re: EXXOS - Populated PCB Availability?
Thanks, ordered.
Re: EXXOS - Populated PCB Availability?
These are almost out of stock again.
I'm trying to order some more but JLC's part placement preview seems to be coming out backwards for no reason. I have not done anything different then I have done previously, so I do not see how I can screw it up.
So I have emailed JLC and asked about it.. Likely this will not get anywhere
I'm trying to order some more but JLC's part placement preview seems to be coming out backwards for no reason. I have not done anything different then I have done previously, so I do not see how I can screw it up.
So I have emailed JLC and asked about it.. Likely this will not get anywhere
- Capture.JPG (64.18 KiB) Viewed 2923 times