Stuff and Things.

[Tomswork]

Very nice does it need a recap ?

Tom

[rubber_jonnie]

Very nice does it need a recap ?

Tom

Not sure, it hasn't arrived yet, those pics are just stolen from eBay...

I'll certaninly be giving it the once over for stuff like that though.

[atari030]

Don't forget to get a Master System cart adapter too.

[Higgy]

Adding a 50/60 switch with region change will be another little fun task.

[rubber_jonnie]

Don't forget to get a Master System cart adapter too.

I'll have a look at that, and want some sort of SD solution too.

[rubber_jonnie]

Adding a 50/60 switch with region change will be another little fun task.

I saw those on eBay, will probably have a look at that once I have it running nicely.

[Higgy]

SD solution will also do Master System ROMs so adaptor is not needed unless you have a load of carts.

Ah you don't need eBay for the 50/60, just a few switches needed unless you want it to change a bit more fancy.

I use this site for all my 50/60 and RGB mods:
https://mmmonkey.co.uk/

Although his old site was better for finding guides, but not as visually impressive.

[rubber_jonnie]

SD solution will also do Master System ROMs so adaptor is not needed unless you have a load of carts.

Ah you don't need eBay for the 50/60, just a few switches needed unless you want it to change a bit more fancy.

I use this site for all my 50/60 and RGB mods:
https://mmmonkey.co.uk/

Although his old site was better for finding guides, but not as visually impressive.

Cool thanks, I will take a look once I've got it

With regards to carts, I tend to just use SD solutions where I can as I don't have the storage for lots of carts, so I guess once I get the SD solution I'll be golden. I just wanted the Sonic cart as it came with the MD I had back in the day

[atari030]

SD solution will also do Master System ROMs so adaptor is not needed unless you have a load of carts.

Good to know, that's another thing to add to my cart.........

[rubber_jonnie]

Well, the controllers and Sonic cartridge arrived, and boom!!

PXL_20221104_130610983.jpg (258.41 KiB) Viewed 1410 times

All working lovely

All I needed to do was clean up the cartridge edge connector and it powered on perfectly

Currently it's just a bare board on my workbench as I'm giving the case a good clean, but I fully expect it to look and run great once it's finished.

I'm only running it on RF out at the moment, so I need to sort out a proper cable to verify if the AV out port is not right as described, but so far so good.