TF536 on the ST

[exxos]

Ok looks like the same issue. How do you stop GLUE decoding it though? I read the relevant comments but didnt notice that.

Likely just stopped GLUE from seeing /AS... That way GLUE doesn't see the address and no DTACK!

Needs a decoder. Exxos is working going to be selling them soon.

First runs are already in my store.

https://www.exxosforum.co.uk/atari/store2/#0172

[terriblefire]

Likely just stopped GLUE from seeing /AS... That way GLUE doesn't see the address and no DTACK!

My instinct was that if i did that then the YM wouldnt get decoded.

First runs are already in my store.

Purchased.

[exxos]

My instinct was that if i did that then the YM wouldnt get decoded.

I decoded the YM address range in my PLD logic and just bypassed GLUE. https://www.exxosforum.co.uk/forum/viewt ... 370#p17550

This is why there is a SND_CS jumper on the H4 ;)

[terriblefire]

My instinct was that if i did that then the YM wouldnt get decoded.

I decoded the YM address range in my PLD logic and just bypassed GLUE. https://www.exxosforum.co.uk/forum/viewt ... 370#p17550

This is why there is a SND_CS jumper on the H4 ;)

Ah now i understand. I have to find a different solution in the TF536. Its main design goal is plug n play.

[terriblefire]

Does anyone have a minimalist HD image i can DD onto a cf card which is known good with TOS2.06?

[PhilC]

Does anyone have a minimalist HD image i can DD onto a cf card which is known good with TOS2.06?

I suspect most of the guys will use the HDDriver which is paid for, as I do myself.

I have a couple of 4gb Ultrasatan images (840mb) which should work if nobody else has something a lot smaller.

[terriblefire]

Does anyone have a minimalist HD image i can DD onto a cf card which is known good with TOS2.06?

I suspect most of the guys will use the HDDriver which is paid for, as I do myself.

I have a couple of 4gb Ultrasatan images (840mb) which should work if nobody else has something a lot smaller.

Hmmm. Nobody using TF534 IDE? :/

[PhilC]

Hmmm. Nobody using TF534 IDE? :/

I've been struggling to get it to work on my Mega 4

[PhilC]

@terriblefire

Actually I should explain a little more.

I'm waiting on a decoder board from exxos, so when that arrives I will make up a simple boot image for the TF534 & 536's. My problem is that I'm having to use an IDE board as a decoder at the moment which obviously doesn't let the TF board work.

Hopefully @agranlund will have a small image to get you started?

[terriblefire]

I think im too spoiled with WinUAE. It can access a CF card like its a raw IDE drive.