does any of these rsve still exist to buy one?}
thanx
You will not be able to post if you are still using Microsoft email addresses such as Hotmail etc
See here for more information viewtopic.php?f=20&t=7296
See here for more information viewtopic.php?f=20&t=7296
BOOKMARK THIS PAGE !
https://www.exxosforum.co.uk:8085/IP_CHECK/
You can unban yourself if needed. It also sends me reports to investigate the ban.
https://www.exxosforum.co.uk:8085/IP_CHECK/
You can unban yourself if needed. It also sends me reports to investigate the ban.
DO NOT USE MOBILE / CGNAT DEVICES WHERE THE IP CHANGES CONSTANTLY!
At this time, it is unfortunately not possible to whitelist users when your IP changes constantly.
You may inadvertently get banned because a previous attack may have used the IP you are now on.
So I suggest people only use fixed IP address devices until I can think of a solution for this problem!
At this time, it is unfortunately not possible to whitelist users when your IP changes constantly.
You may inadvertently get banned because a previous attack may have used the IP you are now on.
So I suggest people only use fixed IP address devices until I can think of a solution for this problem!
Recreating the RSVE mod…
-
frank.lukas
- Posts: 811
- Joined: 19 Jan 2018 11:52
Re: Recreating the RSVE mod…
I have PCB´s you can buy or a ready build up one. Also RS-Speed ones too ...
You do not have the required permissions to view the files attached to this post.
-
Pacman
- Posts: 253
- Joined: 28 Aug 2017 00:56
- Location: Norway
Re: Recreating the RSVE mod…
Does anyone know if the RSVE board is actually completely disabled (as if it wasn't there in the first place) when the computer boots up without the HSMODA drivers (DRVIN.PRG and MFP.PRG in the AUTO folder)?
I'm asking because if I plug something like a C-Lab Export into the serial port (it adds 3 MIDI OUT ports) I'm concerned the RSVE will still take processing power from the CPU and/or the MFP chip which could lead to timing instability and unreliability when using MIDI sequencing software. Is there any truth to this?
Do I need to add an enable/disable switch (see the STe schematic section below) so that I can physically disable it and bring the MFP connections together as the computer originally was set up?
I'm asking because if I plug something like a C-Lab Export into the serial port (it adds 3 MIDI OUT ports) I'm concerned the RSVE will still take processing power from the CPU and/or the MFP chip which could lead to timing instability and unreliability when using MIDI sequencing software. Is there any truth to this?
Do I need to add an enable/disable switch (see the STe schematic section below) so that I can physically disable it and bring the MFP connections together as the computer originally was set up?
You do not have the required permissions to view the files attached to this post.
STe | MonSTer with dual IDE-CF memory card adapter | NEC Multisync 1990SXi | ST_ESSC | RSVE | Link '97 | Sony HD floppy drive/AJAX controller | Exxos HD floppy module | Battery-backed Ricoh realtime clock module | Discovery cartridge | C-Lab Unitor-2 | C-Lab Export | C-Lab Combiner | C-Lab Steady Eye | C-Lab Human Touch | Unicorn USB
💧Are you a good person? 💧Living Waters
💧Are you a good person? 💧Living Waters
Who is online
Users browsing this forum: CCBot and 35 guests