MegaST PSU voltage

[dml]

Does anyone know which fixed resistor is used for 5V regulation feedback on a MegaST power supply?

From the schematic, I'm guessing this is R14/R13 since these form a divider across 5V/GND and there is a small stabilizing cap across R13...

If anyone knows differently, please say before I mess with it

Screenshot 2025-08-04 at 14.07.48.png (146.47 KiB) Viewed 2907 times

[exxos]

Yeah probably them. I just normally slap like 100K across them and then see if the voltage goes up or down a bit..

[dml]

Yeah probably them. I just normally slap like 100K across them and then see if the voltage goes up or down a bit..

that was my thought exactly

[rubber_jonnie]

@exxos is probably right, but looking at a datasheet for Q3, which is a voltage reference, it could also be R11 & R12 since the external components for the TL431 determine the voltage that it gives as it's reference, at least from what I understand.

Screenshot 2025-08-04 at 15.29.43.png (217.04 KiB) Viewed 2893 times

Just a thought, probably needs somebody who knows electronics very well to determine.

[dml]

Yes I think there are two parts to it - one (TL431) generates the fixed reference voltage and the second part is the measurement (the stabilised divider feeding back from the 5v rail). I think its the second part (measurement) which would be adjusted against the first (fixed reference).