Basilisk II Atari

[frank.lukas]

@agranlund ... working on a 020 version of Basilisk.

basilisk_020.jpg (305.77 KiB) Viewed 3839 times

[frank.lukas]

How to set up a TOS extfs in the .inf files correctly?

[peters]

I found Basilisk through Atari forum and and mentioned my issues there but I think there are more people using it here.

I think I've installed everything needed but cannot get very far.

So far when I press Start it complains that it cannot find the ROM and the machine locks up.

Has anyone else tried it on 060 hardware ?

[peters]

This is my set up.

basilisk.JPG (34.57 KiB) Viewed 3648 times

[peters]

I've moved the installation folder to a vfat partition.

I also tried the Performa ROM again. Basilisk complained about the ROM being the wrong size, not 512k or 1M. Then it locked up the machine again requiring a lengthy reboot (ext2!).

[arti040]

Hi guys!
I tried to set it up yesterday using ROMs from http://www.happydaze.se/basiliskii/ but I'm constantly getting an info that ROM is not correct. What am I doing wrong?

(config - HATARI - 030, MMU ON, 4MB ST-RAM, 4MB TT-RAM, TT-RAM emulation, Geneva/Neodesk)

[andresv]

Hi there, i just installed a TwiSTer board in my STE. It has a 68020 running at 24mhz with 8mb of TT RAM.

Unfortunately it didnt work, failed booting with ERROR TYPE 97.

I'm doing something wrong?

Thanks!!

20231028_225424.jpg (543.03 KiB) Viewed 2919 times

[stephen_usher]

There may be an extension installed which only works on 68030 and above. As suggested try booting with shift held down.

[frank.lukas]

With my PAK68/3-020 and Fastram all works fine it has a full 32bit CPU ...

[Badwolf]

Oh wow. I was about to post that I thought Basilisk II required the MMU so wasn't going to work on an 020, but I see Anders' website says the following:

Code: Select all

68020, 68030, 68040 or 68060
FPU is optional, MMU is required on 68030+

Which is remarkable!

I'd suggest give it a go on Hatari (ST High mode) and see if you get the same error?

BW