H5 B1 PRODUCTION PROGRESS

[exxos]

Started a new "count down" thread for the next batch of boards. We gone from H5 REV A3 to REV B1 now. The shorted vias have all been fixed. The regulator has been updated to use AZ1084CD which *should* be fitted by JLC now. I think they have extended the extended parts count as 3 parts couldn't be fitted before, and now they are The MAX238 is unfortunately still out of stock

I have checked DRC a million times, and so has @Icky . I even ran CAM350 DRC check as well. I have done a bit more labeling on the B1 so hopefully make it easier to see what jumpers are for etc. Default settings are marked with a white line.. Not all jumpers have a default setting, its depends what the user wants. The MONO/COLOUR has been fixed (Again).. We have a proper PLCC socket for the MFP as well.. hopefully I managed to fix the libraries for all this properly this time.. There have been various other minor tweaks here and there which are not worth mentioning as well.

Again huge thanks to everyone who is supporting this project! There would be no progression of boards without people support here!

Capture.PNG (140.36 KiB) Viewed 4820 times

I'm just waiting for my credit card balance to clear (hopefully will be later today) then I can punch the complete order button

EDIT:

As a side note. There are approximately 20 boards already spoken for (outstanding orders) so there will only likely be about 10 available left in this batch at most.

Ordering options and information is here https://www.exxosforum.co.uk/forum/viewt ... 149#p49096

STORE LINK

https://www.exxosforum.co.uk/atari/store2/#0199

[dragmar]

have all the fixes from the A3 version been corrected in the H5 REV B1 version, including SIDE0 FLOPPY SHORT FIX?

[exxos]

have all the fixes from the A3 version been corrected in the H5 REV B1 version, including SIDE0 FLOPPY SHORT FIX?

Yep.. They are all fixed as I found them anyway.

[PhilC]

Cool, will purchase a couple at the end of the week.

[exxos]

As a side note. There are approximately 20 boards already spoken for (outstanding orders) so there will only likely be about 10 available left in this batch at most.

[sporniket]

[PaulJ]

@exxos , sign me up for “1”.

[agranlund]

Pre-ordered one off the store, looking forward to finally building one of these!

[exxos]

Bit of progress!

Capture.PNG (43.01 KiB) Viewed 4675 times

[PhilC]

Any left if I order tomorrow?