Here's a problem:
A set of signals select the enable for an output.
Later another signal pulses high then low after this is enabled.
The output selected must then be disabled on the falling edge of the second signal. The state is reset when the selection terminates.
How would I go about doing this using an ATF16V8B GAL?
It would have to go into register mode I would imagine.
Any experts here?
GAL programming conundrum.
-
stephen_usher
- Site sponsor
- Posts: 7695
- Joined: Mon Nov 13, 2017 7:19 pm
- Location: Oxford, UK.
- Contact:
GAL programming conundrum.
Intro retro computers since before they were retro...
ZX81->Spectrum->Memotech MTX->Sinclair QL->520STM->BBC Micro->TT030->PCs & Sun Workstations.
Added code to the MiNT kernel (still there the last time I checked) + put together MiNTOS.
Collection now with added Macs, Amigas, Suns and Acorns.
ZX81->Spectrum->Memotech MTX->Sinclair QL->520STM->BBC Micro->TT030->PCs & Sun Workstations.
Added code to the MiNT kernel (still there the last time I checked) + put together MiNTOS.
Collection now with added Macs, Amigas, Suns and Acorns.