Falcon030 dead after Centuriontech CT60/CT60PSU incident - investigation begins

[exxos]

Now has a hat.

IMG_5373.JPG (108.21 KiB) Viewed 60 times

[HigashiJun]

Looks good, especially with the exxos brand on top of the hat.

[exxos]

Looks good, especially with the exxos brand on top of the hat.

Yeah, it's getting better each week

[HigashiJun]

Yeah, it's getting better each week

Indeed it is !

[exxos]

This is the mains section on the PSU PCB, don't think I overlooked anything ?

The thicker white lines are slots on the PCB. RED is top layer, BLUE is bottom layer. Has a cap and a MOV for mains spike protection. The small 3 way connector will be the same as used on the original Falcon PSU. I will remove the center pad and the middle pin will be pulled from the connector.

Main "problem" is the 3 way connector has a huge isolation slot which is chopping the support away for the connector mounting to the PCB.

Capture.PNG (39.94 KiB) Viewed 19 times

[mikro]

Sorry to nit-pick but shouldn't all of those recent posts go to the other thread related to CT60 PSU design?

[exxos]

Ah yes.. I'll move them tomorrow.

[HigashiJun]

Do-It.gif (492.6 KiB) Not viewed yet