Falcon030 dead after Centuriontech CT60/CT60PSU incident - investigation begins

[exxos]

DSP mixing, double the sample rate now

Capture.PNG (23.24 KiB) Viewed 71 times

I'm running out of room in the Falcon ROM now

The buffer underrun on the CPU is a speed limitation of ROM access... if only it ran faster...

[JezC]

@exxos Can't you use the Hitachi EPROMs for this rather than OTP ROMs (Microchip/Armel) to save a bit of cost?

You still have them listed in your store

Edit - I'll be interested in the final version for my Falcon too (if/when it breaks again)...

[exxos]

@exxos Can't you use the Hitachi EPROMs for this rather than OTP ROMs (Microchip/Armel) to save a bit of cost?

You still have them listed in your store

Yeah, but I spend more time trying to straighten the pins on the things than anything.. and I get in a bother as I don't know if the code is broken or the ROM is not making good contact.

I keep trying to find some better EPROMs, but not had any luck so far

[exxos]

This is getting complicated

Capture.PNG (235.74 KiB) Viewed 49 times

IMG_5334.JPG (288.53 KiB) Viewed 49 times

Most likely make the end posts out of metal.. because.. reasons..

Possible if the socket pins bend a bit, the wires can flow more at 45 deg and can then get some heat shrink tubing over them. Failing that, might have to resort to liquid bodge tape or resin

[DoG]

Are you planning to use a relay for the 030/060 switch or how is that going to be solved?

[exxos]

Are you planning to use a relay for the 030/060 switch or how is that going to be solved?

Already solved. Actually solved years ago.. Just have to build it.. Wait and see

[exxos]

Worth the effort or soldertail fuse?

20261013_220921.jpg (177.88 KiB) Viewed 30 times

[alexh]

Can't you boot from the cartridge port? Then you could use cheap UV Eproms or a Sidecartridge.

[mikro]

Must have "blown" £100 on ROM's so far

Btw, this would be a really nice project. There's a ton of solutions for putting replacement chips/PCBs into ST/STE sockets but when it comes to Falcon, zero. So anyone with Falcon is stuck with the stock ROM and yeah, when you are investigating a broken machine, wiring up CT60 (to use its flash from) and wait for it to take the lead in booting is quite pointless...