Kochise wrote: Wed Oct 07, 2026 6:09 pm There was KFC, now there is CFF : Centuriontech Fried Falcon.
Can all registered uses please login, even just for a few minutes..
It helps build a picture where our "good traffic" is coming from..
Thanks :)
It helps build a picture where our "good traffic" is coming from..
Thanks :)
Falcon030 dead after Centuriontech CT60/CT60PSU incident - investigation begins
Re: Falcon030 dead after Centuriontech CT60/CT60PSU incident - investigation begins
Re: Falcon030 dead after Centuriontech CT60/CT60PSU incident - investigation begins
Just for the sake of completeness.. This is the top and bottom of the PSU board...
- IMG_5305.JPG (302.38 KiB) Viewed 20 times
- IMG_5307.JPG (312.18 KiB) Viewed 20 times
-
stephen_usher
- Site sponsor
- Posts: 7596
- Joined: Mon Nov 13, 2017 7:19 pm
- Location: Oxford, UK.
- Contact:
Re: Falcon030 dead after Centuriontech CT60/CT60PSU incident - investigation begins
That doesn't look too bad a design in terms of safety.
Intro retro computers since before they were retro...
ZX81->Spectrum->Memotech MTX->Sinclair QL->520STM->BBC Micro->TT030->PCs & Sun Workstations.
Added code to the MiNT kernel (still there the last time I checked) + put together MiNTOS.
Collection now with added Macs, Amigas, Suns and Acorns.
ZX81->Spectrum->Memotech MTX->Sinclair QL->520STM->BBC Micro->TT030->PCs & Sun Workstations.
Added code to the MiNT kernel (still there the last time I checked) + put together MiNTOS.
Collection now with added Macs, Amigas, Suns and Acorns.
Re: Falcon030 dead after Centuriontech CT60/CT60PSU incident - investigation begins
Still doesn't look much gap on the top track as its mains. Not much clearance to the ground pad either.. or much gap between the N-E-L pins on the connector, looks smaller gap than what flashed over on the switch PCB!stephen_usher wrote: Thu Oct 08, 2026 7:44 pm That doesn't look too bad a design in terms of safety.