Sun Ultrasparc

[Oldskool]

So not really sure why I bought this.
Don’t know the status or if it works.
It is very clean inside however the case is very yellow.

Spec:
Sun is ultrasparc 1 64 bit with 3 d creator videocard. It has some early 3d capabilities
It has 192mb of memory 167mhz cpu. 2gb hd and cdrom.
Have not yet tried to power it up as I don’t have correct video converter or serial 0 modem cable.
It’s not as cool as a SGI or next but those are very expensive.

So waiting for the correct cables. First boot in serial mode is probably best for the best check.

I can post updates.

Some pictures

IMG_4171.jpeg (67.55 KiB) Viewed 30 times

IMG_4170.jpeg (111.88 KiB) Viewed 30 times

IMG_4168.jpeg (97.41 KiB) Viewed 30 times

IMG_4165.jpeg (196.99 KiB) Viewed 30 times

IMG_4163.jpeg (115.34 KiB) Viewed 30 times

[rubber_jonnie]

Nice.

To be fair, I don't know why I bought 2 SGI Octanes, but here we are...

Have fun spinning it up

[Oldskool]

Yeah SGI has the “cool” factor.
Those cases are awesome.

This was however still in the just for fun price..
I hope I can get the system to post.

There used /seems to be some interesting software and emulators for Solaris.

[stephen_usher]

You'll need to replace the battery in the NVRAM and then re-enter the MAC address into it before you'll be able to connect to a network.

The Creator 3D version of the Ultra 1 was the expensive one by the way.

You should be able to just use a 13W3 to VGA converter and then use a multisync monitor which does sync on green.

With a flat NVRAM battery the machine will start in diag mode, do a lot of tests (sending stuff out of serial port A) before it even tries to initialise the display, which happens near the end of the POST. It will then try to boot from network.

Once you have the NVRAM battery replaced and written the MAC address and serial number to the NVRAM you can run "setenv diag-switch? false" and this will return the machine to normal operation.