exxos's Atari, Amiga & retro forum

i have my adapter that have arrived and looking at building them.

first-
has anyone else built them and if so which way round do you build them,
from what i can see you solder in the set of inner long pins for each side then the socket then outer pins, would this be right?.

second,
once built do you push them all the way down to the sts board solder in and cut legs down or leave then high on the board?.

Have you looked at the build instructions here: https://exxosforum.co.uk/atari/last/blitter/index.htm

rubber_jonnie wrote: 16 Aug 2024 21:33 Have you looked at the build instructions here: [https://exxosforum.co.uk/atari/last/blitter/index.htm

no as that didnt show when searching, thank you for the link as that will heal greatly

thecaver99 wrote: 17 Aug 2024 10:25

rubber_jonnie wrote: 16 Aug 2024 21:33 Have you looked at the build instructions here: [https://exxosforum.co.uk/atari/last/blitter/index.htm

no as that didnt show when searching, thank you for the link as that will heal greatly

Just for future reference there is a note on the site:


So the 'i' button will always take you to the help pages for an item if you're ordering any more parts in the future :)

rubber_jonnie wrote: 16 Aug 2024 21:33 Have you looked at the build instructions here: [https://exxosforum.co.uk/atari/last/blitter/index.htm

There is a typo (leading bracket) on the link https://exxosforum.co.uk/atari/last/blitter/index.htm

sporniket wrote: 17 Aug 2024 10:37

rubber_jonnie wrote: 16 Aug 2024 21:33 Have you looked at the build instructions here: [https://exxosforum.co.uk/atari/last/blitter/index.htm

There is a typo (leading bracket) on the link https://exxosforum.co.uk/atari/last/blitter/index.htm

Fixed, stupid paste on my mobile...