Page 1 of 1
Atari 520ST Power Brick PSU
Posted: 01 Mar 2018 16:00
by Icky
Finally I got my hands on an Atari 520ST power brick. A rather large piece of plastic.
I now have a new project for this weekend to clean up and pop it open to see what is inside and if it can be re-capped. Will add new pics as I open it up.
IMG_2753.JPG
Re: Atari 520ST Power Brick PSU
Posted: 03 Mar 2018 14:40
by Icky
Well I managed to pop the brick open by carefully putting a knife down the seam to break the old glue.
Its a NORTEL PNE-5
I did not expect to see this when I opened it up.
IMG_2756.JPG
A load of epoxy resin around the transformer and it looks like the epoxy has stuck two of the fine wires from the transformer together (second and third wire down) see pic below:
IMG_2761.JPG
Re: Atari 520ST Power Brick PSU
Posted: 03 Mar 2018 23:06
by Icky
Pictures of the component side of the PSU board. Haven't started to clean it up yet so its a bit dusty.
Look like its only 5 re-caps
IMG_2760.png
IMG_2758.png
IMG_2757.png
Re: Atari 520ST Power Brick PSU
Posted: 04 Mar 2018 22:15
by exxos
Nice! Whats the 8pin chip number ?
Re: Atari 520ST Power Brick PSU
Posted: 04 Mar 2018 22:55
by Icky
exxos wrote: 04 Mar 2018 22:15
Nice! Whats the 8pin chip number ?
Chip is NE5561N
Caps are 2x 470uF 25V and 3x 4700uF 16V
Re: Atari 520ST Power Brick PSU
Posted: 04 Mar 2018 23:02
by exxos
Can't seem to find a schematic for it anywhere ?
Re: Atari 520ST Power Brick PSU
Posted: 04 Mar 2018 23:24
by Icky
exxos wrote: 04 Mar 2018 23:02
Can't seem to find a schematic for it anywhere ?
Indeed I too had a look around. I guess whilst I clean it up I'll draw out the schematic - its no bother. I'm interested to find out how its configured.