exxos's Atari, Amiga & retro forum

So I finally picked up one of those nice Dell 27" monitors that a lot of people have
been going on about. It is a nice monitor.

I've been using one of the Ube switch's, Mark IV I think, that has "Make Atari Great Again"
stamped on it.

It works great, picture is awesome. The only thing is, it always boots up in Hi-res. I can
switch it to Med-res by pressing the button but as soon as I turn the machine off, it defaults
back to Hi-res.

Is there a way to make it use Med-res all the time instead of defaulting to Hi-res? Thanks.

Doesn't sound like a official once I was buying from urban . can you post a image ?

IIRC you held down the button for a few seconds to store the value.

exxos wrote: 30 Aug 2022 02:13IIRC you held down the button for a few seconds to store the value.

are you KIDDING me, I've been nudging the button to get the correct mode for years :lol:

stween wrote: 30 Aug 2022 03:58

exxos wrote: 30 Aug 2022 02:13IIRC you held down the button for a few seconds to store the value.

are you KIDDING me, I've been nudging the button to get the correct mode for years :lol:

viewtopic.php?f=27&t=161

:chairsmack:

exxos wrote: 30 Aug 2022 08:24

stween wrote: 30 Aug 2022 03:58
are you KIDDING me, I've been nudging the button to get the correct mode for years :lol:

viewtopic.php?f=27&t=161

:chairsmack:

"Every time I learn something new, it pushes some old stuff out of my brain" :lol:

stween wrote: 30 Aug 2022 14:15 "Every time I learn something new, it pushes some old stuff out of my brain" :lol:

Know the feeling. My brain has a high-rate turnover of information. Here today, Gone tomorrow. :lol:

exxos wrote: 30 Aug 2022 14:52

stween wrote: 30 Aug 2022 14:15 "Every time I learn something new, it pushes some old stuff out of my brain" :lol:

Know the feeling. My brain has a high-rate turnover of information. Here today, Gone tomorrow. :lol:

**insert here a joke about cache memory, shortage of components, etc...**

I had thought there was a way to do it, just couldn't remember.

Thanks everyone. :)

PS I've seen 3D cases for the ST2VGA version of this switch, is
there one for this version? I did a search "ube switch 3d case"
but didn't see anything...