Page 1 of 2
bare minimum components
Posted: 25 Apr 2019 16:22
by roy-forest-fc.goodall
what are the bare minimum components required to program cpld's on tf534?
Re: bare minimum components
Posted: 25 Apr 2019 16:26
by terriblefire
Both CPLDS and the regulator.
Re: bare minimum components
Posted: 25 Apr 2019 19:18
by roy-forest-fc.goodall
so no caps etc then?
Re: bare minimum components
Posted: 25 Apr 2019 19:22
by terriblefire
The regulator caps yet.
To ID the jtag chain and program you can probably get away with no caps on a 4 layer board.
Re: bare minimum components
Posted: 25 Apr 2019 22:08
by roy-forest-fc.goodall
Ok thanks for the info
Re: bare minimum components
Posted: 26 Apr 2019 07:19
by roy-forest-fc.goodall
one final question
Do i need the flash mem/rom installed to use the tf534 in a 500
Re: bare minimum components
Posted: 26 Apr 2019 07:27
by terriblefire
Not at all
Re: bare minimum components
Posted: 26 Apr 2019 17:25
by roy-forest-fc.goodall
so I lied about one final question :)
what is the best firmware to use?
Re: bare minimum components
Posted: 26 Apr 2019 17:27
by terriblefire
Use the latest from the TerribleFire binaries github page
Re: bare minimum components
Posted: 26 Apr 2019 17:31
by roy-forest-fc.goodall
and which end is pin one on the ide connector
and you are a top man for answering these questions :)